上海荣计达仪器科技有限公司

021-61997300 13761118616

累积点滴改进  迈向完美品质

www.rongjida.cn

图片展示
搜索

分散多用机

该产品保持了搅拌、砂磨、分散多种的功能于一体的优点。电机采用了变频鼠笼电机、无电刷、使用寿命长,噪音更低,适合在实验室里使用。为了便于操作,变频器直接安装在机器上。

 

一,分散多用机产品简介:
该产品保持了搅拌、砂磨、分散多种的功能于一体的优点。电机采用了变频鼠笼电机、无电刷、使用寿命长,噪音更低,适合在实验室里使用。为了便于操作,变频器直接安装在机器上。变频器的显示屏直接显示转轴转速。 是采用国外新技术新产品,该产品集中了搅拌、砂磨、分散多种设备的功能于一体,采用变频无极调速,变频器显示屏直接显示转轴转速。
First, the product introduction:
The product maintains the advantages of mixing, sanding and dispersing a variety of functions. The motor uses a variable frequency squirrel cage motor, no brush, long service life and low noise, which is very suitable for use in the laboratory. For ease of operation, the frequency converter is mounted directly on the machine. The display of the inverter directly shows the speed of the shaft. It adopts foreign new technology and new products. This product integrates the functions of mixing, sanding and dispersing various equipments. It is the most ideal test equipment for laboratory personnel. The frequency conversion stepless speed regulation is adopted, and the inverter display directly displays the rotation speed of the shaft.

二,分散多用机技术参数:
♦电机功率:550W。
♦变 频 器:750W。
♦输入电源:220V,50Hz。
♦调速范围:0~10000r/min(无级调速)。
♦分散叶片直径:Ø50mm,Ø60mm。
♦砂磨盘直径:Ø50mm,Ø60mm。
♦升降行程:280mm。
♦料桶容积:1.3升(双层、可冷却)。

外形尺寸:450X420X550mm

重量:40kg
Second, technical parameters:
♦ Motor power: 550W.
♦ Frequency converter: 750W.
♦ Input power: 220V, 50Hz.
♦ Speed range: 0~10000r/min (stepless speed regulation).
♦ Dispersed blade diameter: Ø50mm, Ø60mm.
♦ Sanding disc diameter: Ø50mm, Ø60mm.
♦ Lifting stroke: 280mm.
♦ Tank volume: 1.3 liters (double layer, can be cooled).

三,分散多用机操作规程:
开车前
♦检查分散机油位是否加注到规定位置,低应加至规定油位,高应放至规定位置。
♦检查三角皮带松紧是否适当。
♦用手盘动叶轮应转动灵活,无磨擦声。
♦检查各紧固件是否松动及各密封部位有无渗漏现象。
♦开启分散机主电机,检查搅拌的旋向是否与设备所规定的方向相同。
♦确认以上检查工作无误后方可开车。
hird, the operating procedures:
Before driving
♦ Check if the oil level of the disperser is filled to the specified position, the low should be added to the specified oil level, and the high should be placed to the specified position.
♦ Check if the V-belt is properly tightened.
♦The impeller should be rotated flexibly by hand, without friction.
♦ Check if the fasteners are loose and there is no leakage at each sealing part.
♦ Turn on the main motor of the disperser and check if the direction of the agitation is the same as the direction specified by the equipment.
♦ Confirm that the above inspection work is correct before driving.
开车
♦将叶轮放在分散机容器的中心位置,揿下降按钮,下降到低位置或要求的位置。
♦两只手柄必须锁紧后才能开车。
♦开主电机,按操作需要转速按下按钮,
♦操作过程中应经常注意电流,如发现超载运转,应停车检查原因,采取措施后再继续运转分散机。
Driving
♦ Place the impeller in the center of the disperser container, and lower the button to lower it to the lower position or the desired position.
♦The two handles must be locked before driving.
♦Open the main motor and press the button at the speed required for operation.
♦ Always pay attention to the current during operation. If overload operation is found, stop the machine for inspection and take measures to continue to operate the disperser.
停车
♦先停主电动机,使叶轮全部停止转动。
♦开分散机上升按钮,使主轴叶轮上升至容器之上,清洗叶轮。
parking
♦ Stop the main motor first, so that the impeller stops rotating.
♦ Open the disperser up button to raise the spindle impeller to the top of the container and clean the impeller.
电源条件:
♦电源电压波动通常交流选用 %10%、-15%,直流允许±%10左右,如若超差,须采取稳压措施或提出特殊订货要求。
♦应根据电源容量选择额定电流和消耗功率。须注意交流起动时VA值较高,在容量不足时应优先选用间接导式分散机。
♦根据供电电源种类,分别选用交流和直流分散机。一般来说交流电源取用方便。
♦电压规格用尽量优先选用AC380V、AC220V 、DC24V。
Power supply conditions:
♦ The fluctuation of the power supply voltage is usually 10%, -15% for AC, and ±10% for DC. If it is too poor, it must adopt voltage regulation measures or make special order requirements.
♦ The rated current and power consumption should be selected according to the power supply capacity. It should be noted that the VA value is higher when the AC starts, and the indirect guided disperser should be preferred when the capacity is insufficient.
♦According to the type of power supply, AC and DC dispersers are used respectively. Generally, AC power is convenient to use.
♦ For voltage specifications, use AC380V, AC220V, and DC24V as much as possible.

四,分散多用机标准配置
♦主机一台(含变频调速器)
♦不锈钢分散盘 2个:直径50mm,60mm各一个
♦尼龙研磨盘:2个:直径50mm,60mm各一个
♦不锈钢夹层料筒1.2L一个
♦夹持手柄2个
Fourth, standard configuration:
♦ One host (including frequency converter)
♦ stainless steel dispersion plate 2: diameter 50mm, 60mm each
♦ Nylon grinding disc: 2: 50mm in diameter, 60mm each
♦ stainless steel sandwich barrel 1.2L one
♦ 2 grip handles



 


分散多用机

长按图片可保存到相册

图片加载中,请稍等 ...
长按图片保存/分享
询盘

咨询表单:

  • 请输入验证码

咨询产品:


你还没有添加任何产品!

询盘

咨询表单:

  • 请输入验证码

咨询产品:


你还没有添加任何产品!

推荐产品

上海荣计达仪器科技有限公司

电话:021-61997300

传真:021-34795918

邮箱:289239104@qq.com

地址:上海市闵行区浦江镇联胜路189号 

邮编:201112 

图片展示

版权所有:上海荣计达仪器科技有限   公司地址:上海市闵行区浦江镇联胜路189号 邮编:201112   沪ICP备11009963号