上海荣计达仪器科技有限公司

021-61997300 13761118616

累积点滴改进  迈向完美品质

www.rongjida.cn

图片展示
搜索

顶击式电动振筛机

顶击式混凝土震筛机是专业筛分仪器,适用于公路、建筑、地质冶金科研等部门的试验室对物料进行筛分分析,每次开机5分钟,既方便又简单完成分级工作。

  • 型号:ZBSX-92A

  • 产品参数
  • 型号:ZBSX-92A

 

一,顶击式电动振筛机是专业筛分仪器,适用于公路、建筑、地质冶金科研等部门的试验室对物料进行筛分分析,每次开机5分钟,既方便又简单完成分级工作。

First, the top-impact concrete sieve screening machine is a professional screening instrument. It is suitable for screening analysis of materials in the laboratory of highway, construction, geological metallurgical research, etc., each time it is turned on for 5 minutes, it is convenient and simple to complete the classification work.

 

二,顶击式电动振筛机技术参数:

★筛子直径:300mm-200mm

★筛子叠高:440mm

★筛座震幅:8mm

★筛摇动次数:221次/分

★震击次数;147次/分

★回转半径:12.5毫米

★电机功率:0.37千瓦

★电机转速:1400次/分

★外形尺寸:(长*宽*高) 600*400*800毫米

★总重量:120kg

Second, the technical parameters of the top impact concrete sieve machine:
 sieve diameter: 300mm-200mm
 sieve stack height: 440mm
 Screen seat amplitude: 8mm
 sieve shake times: 221 times / min
 number of shocks; 147 times / min
 radius of gyration: 12.5 mm
Motor power: 0.37 kW
 Motor speed: 1400 times / min
Dimensions: (length * width * height) 600 * 400 * 800 mm
 Total weight: 120kg

 

三,顶击式电动振筛机操作规程:

开机前,拧出上螺栓,加足润滑油,用20号普通机油5公斤为宜,装筛时先将钮紧螺栓左旋以松动开筛盖故地功能顶杆。然后连同筛盖往上提,然后右旋固定就可置套筛与筛托盘上,再将拧紧螺栓左右松开往下压并右旋使之固定即可工作,根据工作需要,需要常开可将旋钮转至常开位,需要定时工作可将旋钮转至要求定时位,需要途中停机,应切断电源开关,让定时钟自行转至停止位置,不能强行扭回。本机保养简单,每隔6个月更换机油一次,使用时注意避免盖板上的7根导杆的变形。

Third, the operating principle of the top impact concrete sieve machine:
Before starting the machine, unscrew the upper bolt and add enough lubricating oil. It is better to use 5 kg of ordinary oil of No. 20. When loading the screen, first turn the button bolt to the left to loosen the cover and open the function ejector. Then, with the sieve cover, it can be lifted up, and then fixed by right-handed to set the sieve and the sieve tray, and then the screw is loosened left and right and pressed rightward to fix it. It can be opened according to the work needs. Turn the knob to the normally open position. You need to work regularly to turn the knob to the required timing. If you need to stop on the way, you should cut off the power switch and let the fixed clock turn to the stop position. It cannot be forcibly twisted back. The machine is easy to maintain, change the oil every 6 months, and avoid the deformation of the 7 guides on the cover when using.

 

四,顶击式电动振筛机保养:

1、将电机线插头在程控器插座上,将电源线插头插在三相线插座上。

2、按下电源开关,显示屏亮,同时出现300秒。

3、设定时间:

a)根据用户需要,按轻接触键△为上调,按▽为下调,每按一次△▽为60秒。

b)根据试验规程设定需要时间,按ON键机械开始工作,运作时指示灯亮。

c)本仪器在正常工作时,需要停机按OFF键盘。

d)每停机一次,应重新设定时间。

e)注意:使用时不要频繁开、关机器,停机后应切断电源

Fourth, the top impact type concrete sieve machine maintenance:
1. Plug the motor cable into the program controller socket and plug the power cord into the three-phase cable socket.
2. Press the power switch and the display will light up for 300 seconds.
3, set the time:
a) According to the user's needs, press the light touch button △ for up-conversion, press ▽ for down, and press △ ▽ for 60 seconds.
b) Set the required time according to the test procedure, press the ON button to start the work, and the indicator light is on during operation.
c) When the instrument is in normal operation, it needs to stop and press the OFF keyboard.
d) Every time you stop, you should reset the time.
e) Note: Do not open or shut down the device frequently during use, and cut off the power after shutdown.

 

五,顶击式电动振筛机工作原理:

本机主要由传动、摆动、震击、夹紧机构及电器等部分所组成。本机由电动机通过主轴,传动轴带动齿轮,由蜗轮再带动凸轮,主偏心轴带动两个副偏心轴,从而使筛座具有回转及震击双重运动。

Fifth, the working principle of the top impact concrete sieve machine:
This machine is mainly composed of transmission, swing, shock, clamping mechanism and electrical appliances. The machine passes the motor through the main shaft, the transmission shaft drives the gear, and the worm wheel drives the cam. The main eccentric shaft drives the two auxiliary eccentric shafts, so that the sieve seat has double movement of rotation and shock.

 

六,顶击式电动振筛机安装与调试

可以不用水泥基础直接安放水泥地面上开动,也可以安装在水泥基础上,基础螺钉尺寸如图:其厚度300毫米。基础露出地面高度及大小或与地面相平,根据具体使用需要而定,按电工规程安装电路与接地,安装完毕接通电源后电动机回转方向与箭头相同,就有震击运动,若相反则电机空运转,此时可换接线头,方能正常开动。

Sixth, the installation and commissioning of the top impact concrete sieve machine
It can be directly placed on the concrete floor without using the cement foundation, or it can be installed on the cement foundation. The size of the basic screw is as follows: its thickness is 300 mm. The foundation is exposed to the height and size of the ground or level with the ground. According to the specific needs of use, the circuit and grounding are installed according to the electrical code. After the power is turned on, the motor rotates in the same direction as the arrow, and there is shock movement. If the motor is reversed, the motor is reversed. When the air is running, the terminal can be replaced at this time to start normally.

 


顶击式电动振筛机

长按图片可保存到相册

图片加载中,请稍等 ...
长按图片保存/分享
询盘

咨询表单:

  • 请输入验证码

咨询产品:


你还没有添加任何产品!

顶击式电动振筛机

立即询盘
询盘

咨询表单:

  • 请输入验证码

咨询产品:


你还没有添加任何产品!

推荐产品

上海荣计达仪器科技有限公司

电话:021-61997300

传真:021-34795918

邮箱:289239104@qq.com

地址:上海市闵行区浦江镇联胜路189号 

邮编:201112 

图片展示

版权所有:上海荣计达仪器科技有限   公司地址:上海市闵行区浦江镇联胜路189号 邮编:201112   沪ICP备11009963号